Neoway N11 V2 - Setting up Transparent UDP Link: +UDPTRANS

N11 V2
AT Command Manual
Copyright © Neoway Technology Co., Ltd
70
mode.
 TCP data can be transparently transmitted after the TCP link is set up
successfully and +TCPTRANS:OK is returned.
9.2 Setting Up Transparent UDP Link: +UDPTRANS
Description
To transparently transmit UDP data
Format
AT+UDPTRANS=<ip>,<port><CR>
Parameter
<ip>: Destination IP address, in xx.xx.xx.xx format or in domain name format
(www.XXXXX.com).
<port>: Destination port ID in decimal ASCII code
Return Value
See the Example.
Example
AT+UDPTRANS =220.199.66.56,6800
OK
+UDPTRANS:OK
A transparent UDP link is set up
successfully.
AT+UDPTRANS=neowayjsr.oicp.net,60010
OK
+UDPTRANS:OK
A transparent UDP link is set up
by using domain name
successfully.
AT+UDPTRANS=220.199.66.56,
+UDPTRANS:ERROR
The command format is
incorrect.
AT+UDPTRANS=220.199.66.56,6800
OK
+UDPTRANS:FAIL
Failed to set up a transparent
UDP link.
AT+UDPTRANS=220.199.66.56,6800
ERROR
ERROR is returned after the
command is executed because
a transparent (TCP, UDP, TCP
server) link has been set up.
Remarks
 The UART does not display the data transmitted to the server after the
transparent UDP link is set up successfully.
 Use +++ to switch the server to the command mode and ATO to switch it to