Neoway N11 V2 User Manual

N11 V2
AT Command Manual
Copyright © Neoway Technology Co., Ltd
32
Remarks
 This command can be used in the transparent transmission of external/internal
protocol stack and CSD function.
 This command should not end with \r or \n.
4.4 Switching Command Mode to Data Mode: ATO
Description
To switch the module from the command mode to the data mode
Format
ATO<CR>
Parameter
N/A
Return Value
CONNECT
CONNECT <text>
NO CARRIER
ERROR
Example
ATO
CONNECT
CONNECT is returned in TCP/UDP transparent transmission
mode and TCP server transparent transmission mode.
ATO
OK
OK is returned after the mode is switched to data mode
successfully in external protocol dialing.
ATO
CONNECT 9600
CONNECT 9600 is returned after the module is switched to
data mode successfully during the operation of CSD function.
ATO
ERROR
ERROR is returned because no transparent transmission link
is set up or no external protocol is used for dial-up internet
access.
Remarks
 This command is used to switch the command mode to the data mode for dial-
up connection through external protocol stack and transparent transmission
through internal protocol stack.
 Commands mode is switched to data mode during the operation of CSD
function.
4.5 Setting Network APN: +NETAPN
Description
To set the network APN

Neoway N11 V2 Specifications

General

Brand	Neoway
Model	N11 V2
Category	Control Unit
Language	English