Neoway N11 V2 - Transparent Mode; Setting up Transparent TCP Link: +TCPTRANS

N11 V2
AT Command Manual
Copyright © Neoway Technology Co., Ltd
69
9 Transparent Mode
9.1 Setting Up Transparent TCP Link: +TCPTRANS
Description
To set up transparent TCP link
Format
AT+TCPTRANS=<ip>,<port><CR>
Parameter
<ip>: Destination IP address, in xx.xx.xx.xx format or domain name format (www.
XXXXXX.com)
<port>: Destination port ID in decimal ASCII code
Return Value
See the Example.
Example
AT+TCPTRANS=220.199.66.56,6800
OK
+ TCPTRANS:OK
A transparent TCP link is set up
successfully.
AT+TCPTRANS=neowayjsr.oicp.net,60010
OK
+TCPTRANS:OK
A transparent TCP link is set up by
using domain name successfully.
AT+TCPTRANS=220.199.66.56,
+TCPTRANS:ERROR
The command is in wrong format.
AT+TCPTRANS=220.199.66.56,6800
OK
+TCPTRANS:FAIL
Failed to set up a transparent TCP
link.
AT+TCPTRANS=220.199.66.56,6800
ERROR
ERROR is returned after the
command is executed because a
transparent (TCP, UDP, TCP
server) link has been set up.
Remarks
 The UART does not display the data transmitted to the server after the
transparent TCP link is set up successfully.
 Use +++ to switch the server to the command mode and ATO to switch it to
the data mode.
 The module will exit from the transparent link if a call or message is incoming.
 At most 4096-byte data can be sent or received per packet in transparent