Neoway N11 V2 - Enabling & Disabling the Terminal Display: ATE1;ATE0

N11 V2
AT Command Manual
Copyright © Neoway Technology Co., Ltd
12
AT+CGREG?
+CGREG: 1,1
OK
When the value of <n> is set to 1, the
current GPRS network registration
status is queried
AT+CGREG?
+CGREG: 2,1,"286F","00000FCA",3
OK
When the value of <n> is set to 2, the
current GPRS network registration
status is queried
AT+CGREG=3
ERROR
The setting parameter is outside the
settable range and returns an ERROR
AT+CGREG=?
+CGREG: (0-2)
OK
Query the parameters that the command
can set
Remark
N/A
2.4 Enabling & Disabling the Terminal Display: ATE1/ATE0
Description
To enable or disable the terminal display function of the AT commands
Format
 ATE1<CR>
 ATE0<CR>
Parameter
N/A
Return Value
See the Example
Example
ATE1
OK
AT
OK
Turn on module AT command echo
function
Send AT, serial tools show "AT" and "OK"
ATE0
OK
OK
Turn off the module AT command echo
function.
Send AT, serial tools only show "OK"
Remark
 The settings by this command will not be saved after the module is powered
off.
 The terminal display function is enabled by default.
 If you enter the command mode after dialing up to connect the network,