Neoway N11 V2 - Setting Up UDP Link (+UDPSETUP)

N11 V2
AT Command Manual
Copyright © Neoway Technology Co., Ltd
65
8 UDP Data Service
8.1 Setting Up UDP Link: +UDPSETUP
Description
To set up a UDP link
Format
AT+UDPSETUP=<n>,<ip>,<port><CR>
Parameter
<n>:Socket number, ranging from 0 to 4
<ip>: Destination IP address, in xx.xx.xx.xx format or domain name format
(www.XXXX.com)
<port>: Destination port ID in decimal ASCII code
Return Value
See the Example.
Example
AT+UDPSETUP=1,220.199.66.56,7000
OK
+UDPSETUP:1,OK
The link to 220.199.66.560.7000
is successfully set up on socket
1.
AT+UDPSETUP=0,neowayjsr.oicp.net,60010
OK
+UDPSETUP:0,OK
The connection to
neowayjsr.oicp.net,60010 is set
up on socket 0 successfully.
AT+UDPSETUP=0,58.60.184.213,11008
+UDPSETUP:0,FAIL
A TCP/UDP link has been set up
on socket 0.
AT+UDPSETUP=1,192.168.20.6,7000
OK
+UDPSETUP:0,FAIL
Fails to set up the connection to
192.168.20.6,7000 on socket 1
because socket 0 is unavailable.
AT+UDPSETUP=5,192.168.20.6,6800
+UDPSETUP:ERROR
The format or the AT command
is incorrect or the socket number
is incorrect.
AT+UDPSETUP=0.58.60.184.213.10012
+UDPSETUP:ERROR
The punctuations in the
command are incorrect.
AT+UDPSET=0,58.60.184.213,10012
The AT command is not