Neoway M590E - Automatic TCP Data Sending

Neo_M590E V1 GPRS Module AT Command Set
Copyright © Neoway Technology Co., Ltd
36
(www.XXXXX.com).
<port>: Destination port ID in decimal ASCII code
Return Value
See the Example.
Example
AT+UDPTRANS =220.199.66.56,6800
OK
+UDPTRANS:OK
A UDP transparent transmission
connection is set up successfully.
AT+UDPTRANS=neowayjsr.oicp.net,60010
OK
+UDPTRANS:OK
A UDP transparent transmission
connection is set up by using domain
name successfully.
AT+UDPTRANS=220.199.66.56,
+UDPTRANS:ERROR
The command format is incorrect.
AT+UDPTRANS=220.199.66.56,6800
OK
+UDPTRANS:FAIL
Failed to set up a UDP transparent
transmission connection.
AT+UDPTRANS=220.199.66.56,6800
ERROR
ERROR
is returned after the command is
executed because a transparent
transmission (TCP, UDP, TCP server)
connection has been set up.
Remarks

The UART does not display the data transmitted to the server after the transparent
transmission UDP connection is set up successfully.

Use +++ to switch the server to the command mode and ATO to switch it to the data
mode.

The module will exit from the transparent transmission connection if a call or
message is incoming.

At most 4096-byte data can be sent or received in transparent transmission mode.

UDP data can be transparently transmitted after the UDP connection is set up
successfully and
+UDPTRANS:OK
is returned.
3.14 Setting Automatic TCP Data Sending: +TCPAUTO
Description
To set automatic TCP data sending
Format

AT+TCPAUTO=<socket>,<operation>[,<mode>,<time>,<length>]<CR>

AT+TCPAUTO=?<CR>
Parameter
<socket>: socket number, ranging from 0 to 5.
<operation>: Operation, ranging from 0 to 3.
0: restore to the default setting
1: set automatic sending
2: start automatic sending
3: stop automatic sending
<mode>: return value mode, which is valid only when <operation> is set to 1.
0: No return value is displayed after the TCP data is (or not) sent successfully.