Neoway M590E - GPRS Network Registration: +CGREG

Neo_M590E V1 GPRS Module AT Command Set
Copyright © Neoway Technology Co., Ltd
4
<ci>: string type; two
-
byte cell ID in hexadecimal format
<Act>:
0: GSM
2: UTRAN
3: GSM w/EGPRS
Return Value
<CR><LF>OK<CR><LF>
<CR><LF>+CREG: <n>,<stat>[,<lac>,<ci>[,<Act>]]
<CR><LF>OK<CR><LF>
<CR><LF>+CREG: (list of supported <n>s)
<CR><LF>OK<CR><LF>
Example
AT+CREG=1
OK
Allow the module to provide
unsolicited network registration code.
AT+CREG?
+CREG: 0,1
OK
Query the network registration status
of the module.
AT+CREG=?
+CREG: (0-2)
OK
Query the value range of the network
registration status.
Remarks
N/A
1.5 GPRS Network Registration: +CGREG
Description
To control the presentation of an unsolicited result code of the module's GPRS network
registration status
Format

AT+CGREG=[<n>]<CR>

AT+CGREG?<CR>

AT+CGREG=?<CR>
Parameters
<n>
: Specifies whether to enable network registration unsolicited result code
0: Disable network registration unsolicited result code (default)
1: Enable network registration unsolicited result code
2: Enable network registration and location information unsolicited result code
<stat>
: GPRS registration status, integer type
0: Not registered, the module is not currently searching an operator to register to
1: Registered the home network
2: Not registered, but the module is currently trying to attach or searching an operator to
register to
3: Registration denied
4: Unknown code