Using the R900
®
BCT to Read a Route
To begin reading a route using the R900BCT, first load a route into the Nomad. See “Loading
and Unloading Data for Handhelds” in the N_SIGHT
®
R900
®
Online Help.
Click to load a route when you are working in the N_SIGHT
®
R900
®
host
software. Press F1 to see the instructions for loading a route to a handheld.
After the route is loaded and the pairing is complete, log in to receive readings. For optimum
RF performance, point the R900 BCT's radio antenna toward the direction of the meter.
Neptune recommends meter readers place the belt clip for their R900 BCT with the
antenna end pointed forward. Human bodies and other structures can interfere with radio
transmission between MIUs and the R900 BCT. Wearing the R900 BCT with the antenna
side pointed forward minimizes that interference.
R900
®
BCT Status Screen in N_SIGHT
®
While the Nomad and the R900BCT are paired, you can access a screen that shows the
status of the R900BCT. You see a message like the following:
Figure 3 – R900
®
BCT Status Screen
8 R900
®
Belt Clip Transceiver Users' Guide
Chapter 2: Using the R900
®
BCT
To Next Page
Loading...
Need help?
General
