Completing the Wiring
Follow these steps to wire the MACH 10.
1. After you connect all three color wires, read the encoder register to ensure proper
connections and the receptacle / MIU is functioning properly.
Figure 9 – Three Colored Wires Connected
2. Take all three connected Scotchloks and push them into the splice tube until fully
enclosed by the silicone grease.
Figure 10 – Splice Tube
Commercial and lndustrial MACH 10
®
Ultrasonic Meter Installation and Maintenance Guide 17
Chapter 4: Installing MACH 10
®
Ultrasonic Meters
To Next Page
Loading...
Need help?
General
