NESS D16 (V4.5) CONTROL PANEL - USER MANUAL
14
OPERATION
EXCLUDING ZONES
The zone light of each Excluded zone will turn on.
[Zone No.] [Zone No.]
or...
Press...
Press...
The
to exit Exclude mode
Enter the zone number of the zone/s to be Excluded.
The EXCLUDE icon will turn on.
EXCLUDE icon will flash continuously.
[User Code]
.
If a detector becomes faulty and cannot be
Sealed when arming the panel, then its zone
may be Excluded so that it does not generate
alarms.
When zones have been Excluded, the
EXCLUDE light flashes continuously while the
panel is Disarmed and also when Armed.
Zones can be excluded while the panel is either
Disarmed or Armed. See notes below.
Zone Exclude IS not permanent. Excluded
zones are automatically INCLUDED next time
the panel is Disarmed.
Zones can be manually included by the same
method as Excluding. Simply use the
[ZONE NUMBER] sequence to turn OFF the
zone lights to be Included.
NOTES
• EXCLUDE E works only when the panel is Disarmed.
• EXCLUDE [User Code] E works in any state.
• EXCLUDE [User Code] E can only exclude the zones in the Area assigned to that code.
To Next Page
Loading...
Need help?
General
