NESS D16 (V4.5) CONTROL PANEL - USER MANUAL
9
OPERATION
ARMING
The control panel must be Armed prior to
vacating the premises in order to detect
intruders. The panel must be disarmed and
not in Program, Monitor, Memory or Exclude
modes.
Note: If the panel is already in alarm, you must
first silence the alarm before you can Arm.
If something is wrong when Arming the control
panel, the normal 3 beeps will be replaced by
other warnings.
10
10 beeps means Mains Power is
turned off or the Backup Battery is low.
One long beep indicates an invalid
entry or an alarm is outstanding and needs to
be reset by entering your User Code first.
SIREN WARNING:
At the end of the exit time, all zones should be
Sealed. If any are Unsealed, the siren will
sound for 2 seconds as a warning to indicate
that those zones have been automatically
excluded. For maximum security, you should
return, Disarm, check the premises and then
Arm again. Continual warnings could mean that
a detector is faulty and may have to be manually
excluded.
If the auto-exclude option is disabled, the siren
will sound for the duration of reset time if a
zone is Unsealed at the end of exit time.
or...
The light should be off.Not Ready
Press...
The icon will turn on.
• Leave the premises within the Exit Delay Time.
• 3 beeps will sound at the end of Exit Delay Time.
[User Code]
NOTE: ARM ONLY codes
Normal user codes can arm the panel only if it is fully disarmed first.
User codes that are programmed to be Arm Only codes can arm the panel from Monitor mode or
from the disarmed state.
See page 20 for User Code Programming.
To Next Page
Loading...
Need help?
General
