NESS D16 (V4.5) CONTROL PANEL - USER MANUAL
28
OPERATION SUMMARY
ARM
DISARM
MONITOR MODE
PANIC
KEYPAD DURESS
EXCLUDING ZONES
VIEW MEMORY
(Monitor Shortcut
must be ON, P62E 3E)
(Arming Shortcut
must be ON, P62E 5E)
(Memory Shortcut
must be ON, P62E 1E)
(Exclude Shortcut
must be ON, P62E 2E)
Press and hold for 4 seconds
(P68E 3E & 4E must be OFF)
Press OFF button twice within 4 seconds
or ON button twice within 4 seconds
P69E 5E must be ON
or
The panel must be in
a Disarmed state first.
To Disarm and/or reset
alarms.
The panel must be in
a Disarmed state first.*
* NOTE ON ARMING: Normal user codes can arm the panel only if it is fully disarmed first.
User codes that are programmed to be Arm Only codes can arm the panel
from Monitor mode or from the disarmed state.
OPERATION
LCD KEYPAD RADIO KEY
To Disarm and report a Duress Alarm, add any
of the digits 5, 6, 8 or 9 before the User Code
when Disarming.
P75E1E must be enabled
Keypad Duress is factory
set for silent reporting
EXCLUDE + ENTER can only
be used when the panel is
disarmed.
EXCLUDE + CODE + ENTER
can be used when the panel
is armed or disarmed.
x 2
x 1
x 1
x 2
Hold
Press repeatedly to display
the last 30 events
Both keys together
(Keypad Panic Shortcut
must be ON, P62E 4E)
or...
or...
or...
or...
or...
or...
[Zone No.]
[Zone No.]
[]5, 6, 8 or 9
[User Code]
[User Code]
[User Code]
[User Code]
[User Code]
[User Code]
[User Code]
Enter the zone numbers
to be Excluded
To exit Exclude mode
To exit Memory mode
View Memory can only be
used when the panel is
disarmed.
To Previous Page
Loading...
Need help?
General
