EasyManuals Logo

Ness D16 User Manual

Ness D16
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
NESS D16 (V4.5) CONTROL PANEL - USER MANUAL
22
EXAMPLE: ARMING THE D16 BY TELEPHONE
1. Dial the D16 telephone number. Listen for one double ring then hang up.
2. Wait 10 seconds, then dial the D16 telephone number again.
The D16 will answer immediately and gives a 2 second beep followed by low tone.
3. PRESS To prepare the D16 ( 3 beeps)
4. PRESS [User Code] to authorise the next command ( 3 beeps)
5. PRESS to Arm the panel ( 3 beeps)
6
. PRESS
to finish and hang up
OPERATING THE D16 BY TELEPHONE
The D16 will allow a user to call in to the
panel, using a standard DTMF telephone,
and remotely Arm or Disarm all areas and
also turn on or off Aux 1 and Aux 2.
To ensure security of operation a user can
only carry out remote operations after
entering a valid user code.
WHAT’S NEEDED:
A telephone with DTMF tones.
A Valid User code programmed in the
D16.
The D16 to be connected (via Mode 3
socket) to a working telephone line at the
installed premises.
You need to know the telephone number
of the line that the D16 is connected to.
REMOTE OPERATION
SEQUENCE OF OPERATION.
1. Phone the D16 telephone number and
listen for the required number of rings
(ring ring...ring ring) and then hang up.
2. Wait 10 seconds and then call the number
again within 50 seconds.
3. The D16 will answer the second call
immediately, sound a beep for 2 seconds
then, after a pause, it will sound a lower
frequency tone. The D16 is now ready to
receive telephone commands.
4. Press the button on the telephone. This
tells the D16 that telephone commands
will follow. It will respond with either 3
beeps if all OK (One long beep means try
again).
5. Now enter a valid User Code (that is
normally used for Arming or Disarming the
D16) followed by the button.
The D16 will respond with 3 beeps if it
recognises the code or 1 long beep to
signal the code was invalid and to try
again.
6. Enter the required command.
See: Summary Of Telephone Commands.
7. Press to finish. This tells the D16 to
hang up. Also, hang up your telephone.
Provided for Download by www.bendigosecurity.com.au

Other manuals for Ness D16

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ness D16 and is the answer not in the manual?

Ness D16 Specifications

General IconGeneral
BrandNess
ModelD16
CategoryControl Panel
LanguageEnglish

Related product manuals