NESS D16 (V4.5) CONTROL PANEL - USER MANUAL
15
The D16 Control Panel stores a comprehensive
event memory including Arming, Disarming,
Low Battery, Mains Fail and Alarms.
The memory is constantly upgraded and the
last 30 events are always available for viewing.
This memory display can only be selected while
the panel is in the Disarmed state.
TO CLEAR THE MEMORY LIGHT
The MEMORY light flashes continuously when
an alarm has occurred as a reminder to view
the alarm memory.
The MEMORY light stops flashing after the
memory is viewed as shown above.
The MEMORY light is automatically cleared
next time the panel is Armed.
MEMORY MODE - EVENTS INDICATED BY KEYPAD LIGHTS:
LIGHT MEMORY EVENT
Zone lights 1–8 .................... Zone alarm
(no lights) ............................ Panel Disarmed
ARMED ................................. Panel Armed (or Area 1 Armed)
ARM2 .................................... Area 2 Armed
MAINS .................................. Mains power failure
BATTERY .............................. Low Battery
TAMPER ............................... Tamper alarm (Siren cover, panel etc)
EXCLUDE .............................. Panic alarm
LINE ...................................... Telephone line fail
RADIO, EXCLUDE .................. Radio Key Panic alarm
RADIO, BATTERY, ZONE ........ Radio Device battery low, (Device number is indicated by zone light/s)
RADIO, BATTERY, ARM ......... Radio Key battery low, (Radio Key number is NOT indicated)
RADIO, TAMPER, ZONE ......... Radio Device tamper alarm (Device number is indicated by zone light/s)
RADIO, MONITOR, ZONE ....... Radio Supervision fail (Device number is indicated by zone light/s)
OPERATION
VIEWING MEMORY
The most recent event will be displayed.
The next most recent event will be displayed.
...and so on (up to 30 events).
or... [User Code]
Press...
Press...
Press...
Press...
Press...
The
to exit Memory mode.
MEMORY icon will turn on.
To Next Page
Loading...
Need help?
General
