NESS D16 (V4.5) CONTROL PANEL - USER MANUAL
23
REMOTE OPERATION
SUMMARY OF TELEPHONE COMMANDS
Prepare to receive commands
Arm Areas
Disarm Areas
Turn Aux 1 Output ON or OFF
Turn Aux 2 Output ON or OFF
Finished – hang up
AUDIBLE FEEDBACK
3 BEEPS:
• The User Code is valid
• Successful Arming or Disarming
• An Auxiliary output has been turned ON.
1 LONG BEEP:
• D16 is already Armed
• Invalid code. Try again.
1 SHORT BEEP:
• An Auxiliary output has been turned
OFF.
NOTES
• If the D16 does not receive commands for periods longer than 10 seconds it will
assume that the call is finished and it will hang up.
• If an alarm occurs which requires the D16 to dial out while attempting remote
control, the D16 will treat the alarm as a priority, give a constant tone as a warning
and then hang up.
• When all remote control commands are finished press to force the D16 to
hang up.
To Next Page
Loading...
