2. Installation
This section describes how to install the LIB-4xxx hardware and software, and the procedures to
access and initially set up the LIB-4xxx through either a local serial interface or a remote Ethernet
connection (Telnet session or Web interface).
2.1 Safety
Before installing the LIB-4xxx, read the “Safety Cautions and Warnings” on pages 3-4 of this manual
and ensure that the requirements noted are met. During installation and maintenance, avoid direct
exposure to laser beams. Specifically, do not look into laser ports. Ensure that each SFP port at
which laser beams are (or will be) present is occupied by an SFP that is locked in position. See the
related SFP manual for details. See "Electrical Safety Warnings" on page 62 for Electrical Safety
Warnings translated into multiple languages.
2.2 Unpacking
Carefully unpack all LIB-4xxx contents.
Verify receipt of all LIB-4xxx components; see “Ship Kit Contents” on page 19.
Place the LIB-4xxx and related materials in the desired install location (e.g., Rack-
mount or Table top). See “Installing LIB-4xxx Hardware” on page 33.
Figure 3: LIB-4xxx Unpacking
Save the LIB-4xxx shipping carton and packing materials for future use.
To Next Page
Loading...