LIB-4400/4424 Installation Guide
| MANUAL Page 43 of 65
The default username is “admin” (no quotes) and the default password is blank (i.e. empty). Help
screens are available through the “?” or “help” commands. One important use of the CLI is to determine
the IP address of a switch through the “ip configuration” command - this is the IP address the web GUI
is available through. An example of the output during boot and of the entering of the “ip configuration”
command is available in Figure 14 above (in HyperTerminal) and Figure 15 below ((in Telnet).
Figure 15: CLI Screen (Telnet)
To Next Page
Loading...