LIB-4400/4424 Installation Guide
| MANUAL Page 25 of 65
Net2Edge SFPs and XFPs are compliant with the Multi-Sourcing Agreement (MSA) ensuring
interoperability with all other MSA compliant networking devices.
Note: DMI option support requires an SFP that supports DMI.
Installing SFPs
The LIB-4xxx lets you install one to four SFP devices of your choice in order to make a fiber
connection.
Figure 7a: LIB-4400 SFP Installation
Position the SFP device at either installation slot, with the label facing up.
Carefully slide the SFP device into the slot, aligning it with the internal installation guides.
Ensure that the SFP device is firmly seated against the internal mating connector.
Make sure the SFP release latch is in the up (closed) position when you insert the cable connector
into the SFP at PORT 1 - PORT 4 (LIB-4400). On the /LIB-4424, rotate the SFP 19- degrees (label
facing down) and insert for the lower row of ports.
Figure 7b: LIB-4424 SFP Installation
Attach an appropriate cable into the SFP module port.
Attach the other end of the cable into the other device.
To Next Page
Loading...