LIB-4400/4424 Installation Guide
| MANUAL Page 42 of 65
Command Line Interface (CLI)
This LIB-4xxx CLI is for experienced network administrators who are responsible for configuring and
maintaining the LIB-4xxx. The CLI offers a comprehensive set of management features for use during
initial setup (set IPs, etc.) and troubleshooting, as well as for day-to-day management (device
management, firmware upgrades, managing security features, etc.).
The LIB-4xxxoffers a rich set of commands through its CLI for performing configuration and status
monitoring. The CLI is accessible through the RS-232 serial console, telnet and SSH, or Telnet/SSH.
The CLI incorporates user authentication for security purposes.
The LIB-4xxx can be managed either locally through an RS232 serial port using the command line
interface (CLI) or remotely using the browser-based graphical user interface (web GUI), or remotely using
Telnet/SSH.
The LIB-4xxx uses a Cisco blue cable to connect.
Set the terminal’s serial port to 115200 baud, 8 data bits, no parity, 1 stop bit, no flow control.
All of the CLI commands and their functions are described in the related CLI Reference manual.
Figure 14: CLI Screen (HyperTerminal)
To Next Page
Loading...