LIB-4400/4424 Installation Guide
| MANUAL Page 30 of 65
Connect Power Wires to the Terminal Block
Strip the wires to the proper length.
Insert the positive and negative power wires into V+ and V- contacts respectively of the terminal
block (note polarity on the chassis of the switch). Make sure the wires are secure.
Insert the positive and negative power wires into V+ and V- contacts respectively into the power
source; make sure the wires are secure. Insert the positive and negative power wires into V+ and V-
contacts respectively into the power source - make sure the wires are secure.
Note that the LIB-4xxx front panel P (power) LED lights and a startup sequence of LEDs light
momentarily. When the sequence stops, only the Power LED remains lit.
Continue with the “Software Install Process” below.
To Next Page
Loading...