Transition Networks Contra Converter Quick Setup Guide
Command: Set Up Misc CES Link Parameters
Syntax: CES link setup misc <link> [<fpp>] [<jitterlen>] [diffserv|tos] [<qosvalue>]
Description: Update the miscellaneous configuration parameters of a logical link, where:
<link> : Logical Link number (1 to 128, may be less on some products).
<fpp> : Number of TDM frames per packet (1-128).
<jitterlen> : Length of the jitter buffer in ms (1-400). Must not exceed 16 x FPP.
diffserv|tos: Quality of Service Type (DiffServ or Type of Service).
<qosvalue> : Quality of Service Value (0-63).
Example: Update the miscellaneous configuration parameters of logical link 1:
>ces link setup misc 1 100 400 Diffserve 20
WARNING
=======
Quality of Service must be between 0 and 255 (inclusive).
Entered value not saved.
Invalid parameter: 20
Syntax:
CES link setup misc <link> [<fpp>] [<jitterlen>] [diffserv|tos] [<qosvalue>]
>ces link setup misc 1 100 400 tos 20
CES LINK 1 CONFIGURATION
========================
Name : FirstLL
Direction : Rx Only
Frames Per Packet : 100
Remote Packet Address : 192.168.1.110
2nd Remote Packet Address : 192.168.1.200
Remote Logical Link : 2
Jitter Buffer Length : 400 ms
Jitter Packets : 32
QOS Type : Type of Service
QOS Value : 20 (0x14)
Delay : Normal
Throughput : Normal
Reliability : Low
Cost : Normal
Precedence : Routine
VLAN Tagging : Disabled
VLAN Tagging ID : 0
VLAN Tagging Priority : 0
>
33604 Rev. A www.transition.com Page 49 of 72
To Next Page
Loading...