Component Weight Notes
E5624 controller-drive tray 27.9 kg (61.52 lb) Maximum configuration
E5660 controller-drive tray 107.13 kg (236.2 lb) Maximum configuration
EF540 flash array 23.64 kg (52.12 lb) Maximum configuration
EF550 flash array 24.63 kg (54.32 lb) Maximum configuration
EF560 flash array 24.63 kg (54.32 lb) Maximum configuration
DE1600 drive tray 26.3 kg (58 lb) Maximum configuration
DE5600 drive tray 25.31 kg (55.8 lb) Maximum configuration
DE6600 drive tray 104.1 kg (229.6 lb) Maximum configuration
2.
Review the following notes.
Caution: Remove all drives from the DE6600 drive tray before moving the cabinet to its final
position.
Attention: Possible equipment damage – Cabinets with DE6600 drive trays ship without
drives to reduce shipping weight. Because a fully-populated cabinet with DE6600 drive trays
can weigh more than 1247.3 kg (2750 lb), make sure that you move the cabinet into place
before you load the drives, and make sure that the floor load capability of the cabinet’s
destination supports that much weight.
Attention: Possible damage to tray components – Do not place a DE6600 drive tray on a flat
surface. Install the DE6600 drive tray in the cabinet before operating or moving drawers.
3. Go to
Acclimate cabinet
on page 11.
Acclimate cabinet
Make sure that the cabinet and the trays are acclimated to the indoor environment before removing
the packing materials.
Steps
1. If the outdoor temperature is below 0°C (32°F), leave the cabinet and trays inside of their crates
indoors for at least 24 hours to prevent condensation.
2. Increase or decrease the 24-hour stabilization period depending on the outside temperature upon
arrival.
Attention: Possible damage to tray components – If the outdoor temperature is below 0°C
(32°F) when you receive your cabinet and trays, do not immediately unpack them or uncrate
them. Exposing cold components to warm indoor temperatures can cause condensation, which
results in component damage or failures.
3. Go to
Remove packing materials
on page 11.
Remove packing materials
Remove the packing materials only after the cabinet has acclimated to the indoor temperature.
Steps
1. Refer to the unpacking instructions included on the front of the shipping crate.
2. Remove the packing materials according to the enclosed instructions.
Install the cabinet |
11
To Next Page
Loading...
Need help?
General
