• E2660 controller-drive tray
• E2760 controller-drive tray
• E5460 controller-drive tray
• E5560 controller-drive tray
• E5660 controller-drive tray
Steps
1.
Reinstall all of the trays in their original locations in the cabinet.
Warning: Risk of bodily injury – An empty tray weighs approximately 56.7 kg (125 lb).
Three persons are required to safely move an empty tray. If the tray is populated with
components, a mechanized lift is required to safely move the tray.
2.
Reinstall all of the components in their original locations in the trays.
To prevent address conflicts and loss of data access, replace all components in the same tray and
in the same location in the tray.
3.
Reinstall all cables to their original locations in the trays.
4. Route the interface cables to the cabinet.
5. Route the main power cords from the cabinet to the two external power sources.
Do not
plug in
the power cords at this time.
6. Go to
Install cable spools and tie wraps
on page 16.
Install cable spools and tie wraps
After you reinstall the trays, install the cable spools and tie wraps. The cable spools and tie wraps
accommodate excess cable length and cable routing for the controllers and the trays.
Steps
1. Install the cable spools and the tie wraps along both sides of the vertical power distribution
outlets.
16 | Installing E-Series 3040 40U Cabinet
To Next Page
Loading...
Need help?
General
