Overview and specifications
This section describes the power requirements and maximum weights for the following E-Series and
EF-Series controller-drive trays and expansion drive trays.
• E2612, E2624, and E2660 controller-drive trays
• E2712, E2724, and E2760 controller-drive trays
• E5412, E5424, and E5460 controller-drive trays
• E5512, E5524, and E5560 controller-drive trays
• E5612, E5624, and E5660 controller-drive trays
• EF540, EF550, and EF560 flash arrays
• DE1600, DE5600, and DE6600 drive trays
Specifications are not provided for the following controller shelves and drive shelves, which can also
be installed in the cabinet.
• E2812, E2824, and E5724 controller shelves
• DE212C and DE224C drive shelves
For specifications for the SAS-3 controller shelves and drive shelves listed above, refer to the
NetApp
Hardware Universe
.
Cabinet features
The model 3040 40U cabinet has these standard features:
• A rear door that can be latched and locked
• Standard Electronic Industry Association (EIA) support rails that provide mounting holes for
installing devices into a standard 48.3-cm (19-in.) wide cabinet
• Four roller casters and four adjustable leveling feet that are located beneath the cabinet for
moving the cabinet and then leveling the cabinet in its final location
• A stability foot that stabilizes the cabinet after it is installed in its permanent location
• Access openings for interface cables
• Two AC power distribution units (PDUs) that provide integrated power connection and power
handling capacity
The following figures show a front view (left) and a rear view (right) of the cabinet.
4
To Next Page
Loading...
Need help?
General
