EasyManuals Logo

NetApp E Series Installation Manual

NetApp E Series
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
Related tasks
Estimate cabinet weight
on page 10
The cabinet reliably and safely transports up to 909.1 kg (2000 lb) of capacity. You need to
know the approximate weight of the cabinet so that you can safely move it.
Complete cabinet installation
After you move the cabinet, lower the leveling feet and the stability foot, reinstall the components
you removed, install other required components, and connect the cabinet to power.
Steps
1. Lower leveling feet and stability foot on page 14
You stabilize the cabinet by adjusting its feet. The leveling feet support the cabinet off the casters.
The stability foot prevents the cabinet from falling over after it is placed in its permanent location
2. Reinstall trays on page 15
After you move the cabinet, you can reinstall the trays in their original locations.
3. Install cable spools and tie wraps on page 16
After you reinstall the trays, install the cable spools and tie wraps. The cable spools and tie wraps
accommodate excess cable length and cable routing for the controllers and the trays.
4. Install additional trays on page 17
If needed, you can install additional trays. You must cover unused positions for trays to assure
correct air flow.
5. Install additional mounting rails on page 18
If you are installing controller-drive trays, or drive trays that were shipped separately (not already
installed in the cabinet), you might need to install additional mounting rails in the cabinet.
6. Connect the cabinet to power on page 20
To complete the cabinet installation, power on the cabinet components.
Lower leveling feet and stability foot
You stabilize the cabinet by adjusting its feet. The leveling feet support the cabinet off the casters.
The stability foot prevents the cabinet from falling over after it is placed in its permanent location
Steps
1. Lower the leveling feet to support the cabinet off the casters.
The leveling feet are located near each bottom corner of the cabinet.
2. Make sure that the cabinet is a level as possible.
The following figure provides a close-up view of the stability foot and the leveling feet.
14 | Installing E-Series 3040 40U Cabinet

Other manuals for NetApp E Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NetApp E Series and is the answer not in the manual?

NetApp E Series Specifications

General IconGeneral
Form Factor2U, 4U
Drive TypesSSD
Host InterfaceSAS, iSCSI, FC, IB
RAID LevelsRAID 0, 1, 5, 6, 10
Operating System CompatibilityWindows, Linux, VMware
Management SoftwareSANtricity

Related product manuals