ADSL
The following configuration options are available on the ADSL tab:
Username
Password
Protocol
VPI Number
VCI Number
To configure your xDSL connection, enter the username and password as supplied by your xDSL service Provider.
Select the applicable protocol for your xDSL service. You can select from:
PPP over Ethernet (or PPPoE)
PPP over ATM (or PPPoA)
Enter the VPI Number (usually 8 for an xDSL service in Australia) and the VCI Number (usually 35 for an xDSL service in Australia)
as supplied by your xDSL service Provider.
If you make any changes to the ADSL configuration, click the Save and apply the changes button to make these changes active.
Note: Saving any configuration changes on this page will make the xDSL connection the primary method of connecting to
the Internet and disable other connection types.
To Next Page
Loading...
