NETGEAR AC1200 JR6100

Security
71
AC1200 WiFi Router JR6100
2. Select the Port Triggering radio button.
3. Clear the Disable Port Triggering check box.
If the Disable Port Triggering check box is selected after you configure port triggering,
port triggering is disabled. However, any port triggering configuration information that you
specified is saved even though it is not used.
4. In the Port T
riggering Timeout field, enter a value up to 9999 minutes.
This value controls the inactivity timer for the designated inbound ports. The inbound
ports close when the inactivity time expires. This is required because the router cannot be
sure when the application has terminated.
 To add a port triggering service:
1. On the Port Forwarding/Port T
riggering screen, click the Add Service button.
2. In the Service Name field, type a descriptive service name.
3. In the Service User list, select Any, or select Single address and enter the IP address of
one computer.
• Any (the default) allows any computer on the Internet to use this service.
• Single address
restricts the service to a particular computer.
4. Select the service type, either TCP
or UDP or TCP/UDP (both). If you are not sure, select
TCP/UDP.
5. In the Triggering Port field, enter the number of the outbound traffic port that will cause the
inbound ports to be opened.
6. Enter the inbound connection port information in the Connection T
ype, Starting Port, and
Ending Port fields.