NETGEAR AC1200 JR6100 User Manual

Administration
83
AC1200 WiFi Router JR6100
Erase the Current Configuration Settings
You can use the Erase button to erase the configuration and restore the factory default
settings. You might want to erase the settings if you move the router to a different network.
You can also use the Reset button on the back of the router to erase the configuration and
restore the factory settings. (See Factory Settings on page 121).
 To erase the configuration settings:
Click the Erase button.
The factory default settings are restored. The password for the user name admin is
password and the LAN IP address is 192.168.1.1. DHCP is enabled.
Change the Password
This feature let you change the default password that is used to log in to the router with the
user name admin.
This is not the same as changing the password for wireless access. The label on your router
shows your unique wireless network name (SSID) and password for wireless access (see
Label on page 11).
 To set the password for the user name admin:
1. Select ADVANCED >
Administration > Set Password.
2. Type the old password, and type the new password twice.
3. If you want to be able to recover the password, select the Enable Password Recovery
check box.
4. Click the Apply button.
Your changes take effect.

NETGEAR AC1200 JR6100 Specifications

General

USB Port	1 x USB 2.0
Parental Controls	Yes
Guest Network	Yes
Wi-Fi Technology	802.11ac
Wi-Fi Performance	AC1200 (300 Mbps + 867 Mbps)
Wi-Fi Band	Dual-band (2.4 GHz & 5 GHz)
Key Features	ReadySHARE USB
Security	WPA/WPA2-PSK