To set up your cable modem router:
1.
Turn off and disconnect existing modems and routers.
If you are replacing a modem that is currently connected in your home, unplug the
modem and plug the new cable modem router into the same outlet.
Note: Xfinity recommends connecting your cable modem router directly to a cable
wall outlet.
2. Connect a coaxial cable.
Use a coaxial cable to connect the coaxial cable connector on the cable modem
router to the cable wall outlet.
3. Connect the power adapter.
Connect the power adapter to the cable modem router and plug the power adapter
into an electrical outlet.
The startup procedure takes about one minute. When it is complete, the Power LED
lights solid green.
If the Power LED does not light, make sure that the Power On/Off button is in the
On position.
4.
Wait for the cable modem router to come online.
This process might take up to three minutes.
Note: When the Online LED lights, your cable modem router is still not connected
to the Internet. You must activate your cable modem router with your ISP.
5. Connect a computer or mobile device to the cable modem router with a WiFi or
wired connection:
•
WiFi. Use the WiFi network name and password on the cable modem router
label.
•
Wired. Use an Ethernet cable to connect a computer to an Ethernet port on the
cable modem router.
6. Launch a web browser and set up your cable modem router.
You are automatically redirected to the cable modem router web interface. If you’re
not redirected, enter http://routerlogin.net or http://192.168.0.1 in the address
field of the web browser.
Follow the prompts to set up your cable modem router.
User Manual16Hardware Setup
AC1750 WiFi Cable Modem Router
To Next Page
Loading...
Need help?
General
