Factory default settings
You can return the switch to its factory settings. For more information, see Return the
switch to its factory default settings on page 74.
The switch resets and returns to the factory settings shown in the following table.
Table 7. Factory default settings
SettingFeature
passwordSwitch password
192.168.0.239 (if the switch is not connected to a network with a DHCP server)IP address
255.255.255.0Subnet mask
EnabledDHCP mode
EnabledIGMP snooping
None configuredLAGs
Disabled. If enabled, by default, all ports are members of VLAN 1.VLANs
Enabled802.1p/DSCP-based QoS
DisabledPort-based QoS
DisabledRate limiting
DisabledBroadcast filtering
DisabledLoop detection
EnabledLoop prevention
AutonegotiationPort speed
DisabledFlow control
DisabledPort mirroring
User Manual106Factory Default Settings and
Technical Specifications
Gigabit Ethernet Plus Switches