NETGEAR GS316EP User Manual

Return the switch to its factory default
settings
You can reset the switch to return it to factory default settings, using either the RESET
button on the front of the switch, or the reset function in the device UI. If you have lost
the password and cannot access the switch, you must use the RESET button.
After you reset the switch to factory default settings, the password is password and the
switch’s DHCP client is enabled. For more information, see Factory default settings on
page 106.
Use the RESET button to reset the switch
You can use the RESET button to return the switch to its factory default settings.
CAUTION: This process erases all settings that you configured on the switch.
To reset the switch to factory default settings:
1.
On the front of the switch, locate the recessed RESET button.
2.
Using a straightened paper clip, press and hold the RESET button for more than
10 seconds or until all port LEDs start blinking red.
3. Release the RESET button.
All port LEDs blink red five times and the configuration is reset to factory default
settings. When the reset is complete, the switch reboots. This process takes about
one minute.
WARNING: Do not interrupt the network connection or power to the switch during
the reset process. Do not disconnect any Ethernet cables or power off the switch
until the reset process and switch reboot are complete. Doing so can damage the
switch.
User Manual74Maintain and Monitor the Switch
Gigabit Ethernet Plus Switches

NETGEAR GS316EP Specifications

General

Switch type	Managed
Quality of Service (QoS) support	Yes
Stackable	-
Certification	FCC 15 B CE/EN55032/24 VCCI ACMA CSA KC BSMI
Product color	Black
Rack mounting	No
Housing material	Metal
Power connector	DC-in jack
SFP module slots quantity	1
Installed SFP+ modules quantity	0
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	16
Mean time between failures (MTBF)	784742 h
Number of VLANs	64
Networking standards	IEEE 802.1Q, IEEE 802.1p, IEEE 802.3, IEEE 802.3ab, IEEE 802.3ad, IEEE 802.3af, IEEE 802.3at, IEEE 802.3az, IEEE 802.3u, IEEE 802.3x, IEEE 802.3z
Virtual LAN features	Port-based VLAN, Tagged VLAN
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Copper ethernet cabling technology	10BASE-T, 100BASE-TX, 1000BASE-T
Sustainability certificates	CE
Jumbo frames	10000
MAC address table	4096 entries
Packet buffer memory	0.192 MB
Total Power over Ethernet (PoE) budget	180 W
Power over Ethernet plus (PoE+) ports quantity	15
DHCP features	DHCP client
Queue scheduling algorithms	Weighted Round Robin (WRR)
Operating altitude	0 - 3000 m
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Cables included	AC
Number of multicast groups filtered	128
Harmonized System (HS) code	85176990

Weight and Dimensions

Depth	102 mm
Width	286 mm
Height	27 mm
Weight	880 g