The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
The BASIC Home page displays.
4.
Select ADVANCED > Advanced Setup > Router / AP Mode.
The Router / AP Mode page displays.
5. Select the Router Mode radio button.
The page adjusts.
6. Click the Apply button.
Your settings are saved.
Set up a bridge for a port group or VLAN tag
group
This feature can function only if you disable the mobile broadband connection entirely
so that the router uses a wired Internet connection only (see Change the Internet
connection mode to wired Internet only or mobile broadband only on page 22) and if
the router function in router mode (its default mode).
Some devices, such as an IPTV, cannot function behind the router’s Network Address
Translation (NAT) service or firewall. Based on what your wired Internet provider requires,
for the device to connect to the wired Internet provider’s network directly, you can
enable the bridge between the device and the router’s wired Internet port or add new
VLAN tag groups to the bridge.
Note: If your wired Internet provider gave you directions on how to set up a bridge for
IPTV and Internet service, follow those directions.
Set up a bridge for a port group
If the devices that are connected to the router’s Ethernet LAN port include an IPTV
device, your wired Internet provider might require you to set up a bridge for a port
group for the router’s Internet interface.
A bridge with a port group prevents packets that are sent between the IPTV device and
the router’s Internet port from being processed through the router’s Network Address
Translation (NAT) service.
User Manual88Specify Network Settings
4G LTE WiFi Orbi Router Model LBR20
To Next Page
Loading...
Need help?
General
