NETGEAR ProSafe GS108T User Manual

GS108T Hardware Installation Guide
Installation 4-5
v1.0, January 2010
Step 6: Managing the Switch using a Web Browser or the PC
Utility
The GS108T Smart Switch contains software for viewing, changing, and monitoring the way it
works. This management software is not required for the switch to work. The ports can be used
without using the management software. However, the management software enables the setup of
VLAN and Trunking features and also improves the efficiency of the switch, which results in the
improvement of its overall performance as well as the performance of the network.
After powering up the switch for the first time, the Smart Switch can be configured using a Web
browser or a utility program called Smart Control Center. For more information about managing
the switch, see the GS108T Software Administration Manual on the Smart Switch Resource CD.
Note: When the device powers up, there is a default IP address already configured on the
device. The default IP address is 192.168.0.239 and subnet mask 255.255.255.0.

NETGEAR ProSafe GS108T Specifications

General

Switching Capacity	16 Gbps
VLAN Support	Yes
QoS	Yes
Model Number	GS108T
Managed	Yes
Forwarding Rate	11.9 Mpps
PoE	No
Management	Web-based
Jumbo Frame Support	Yes
Operating Temperature	0°C to 40°C
Storage Temperature	-20°C to 70°C
Humidity	90% maximum relative humidity, noncondensing
Ports	8 x Gigabit Ethernet