•
Your Internet service provider (ISP) might require a login program. Ask your ISP whether they require
PPP over Ethernet (PPPoE) or some other type of login.
•
If your ISP requires a login, the login name and password might be set incorrectly.
•
Your ISP might check for your computer’s host name. Assign the computer host name of your ISP account
as the account name on the Internet Setup page.
•
If your ISP allows only one Ethernet MAC address to connect to Internet and checks for your computer’s
MAC address, do one of the following:
•
Inform your ISP that you bought a new network device and ask them to use the router’s MAC address.
•
Configure your router to clone your computer’s MAC address.
If your router obtained an IP address, but your computer is does not load any web pages from the Internet,
it might be for one or more of the following reasons:
•
Your computer might not recognize any DNS server addresses.
A DNS server is a host on the Internet that translates Internet names (such as www addresses) to numeric
IP addresses.Typically, your ISP provides the addresses of one or two DNS servers for your use. If you
entered a DNS address during the router’s configuration, reboot your computer, and verify the DNS
address.You can configure your computer manually with DNS addresses, as explained in your operating
system documentation.
•
The router might not be configured as the TCP/IP gateway on your computer.
If your computer obtains its information from the router by DHCP, reboot the computer and verify the
gateway address.
•
You might be running login software that is no longer needed.
If your ISP provided a program to log you in to the Internet (such as WinPoET), you no longer need to
run that software after installing your router.You might need to go to Internet Explorer and select Tools
> Internet Options, click the Connections tab, and select Never dial a connection. Other browsers
provide similar options.
Troubleshooting
175
To Next Page
Loading...
Need help?
General
