NETGEAR RangeMax WPN824 User Manual

Reference Manual for the RangeMax Wireless Router WPN824
8-4 Advanced Configuration of the Router
202-10072-01, March 2005
d.
When you have finished entering the MAC address, return to the Wireless Access List
menu by clicking the Add button.
Note: Repeat steps a - d for each wireless PC.
e. Click the Turn Access Control On box to enable Access Control.
f. Click the Apply button to save changes and return to the Wireless Settings page.
Wireless Card Access Setup
The Wireless Card Access Setup screen is invoked by clicking Add on the Wireless Card Access
List menu (see “Wireless Card Access List“ on page 8-3):
Figure 8-3: Wireless Card Access Setup screen
Program the Wireless Card Access Setup menu as follows:
• Available Wireless Cards—The Available Wireless Cards list displays any available wireless
PCs and their MAC addresses.
If the wireless PC appears in the Available Wireless Cards list, you can click on the radio
button of that PC to capture its MAC address. If your wireless PC is not displayed, make sure
that the PC is configured correctly, and then click on the Refresh button to update the available
list of wireless PCs. If the wireless PC is still not displayed, then follow the instructions below
on how to manually setup the wireless PC's MAC address.
• Wireless Card Entry—If no wireless PCs appears in the Available Wireless Cards list, you
can manually enter the Device Name and MAC address of the authorized wireless PC.

NETGEAR RangeMax WPN824 Specifications

General

Bandwidth	2.4 GHz
xDSL connection	Yes
Dimensions (WxDxH)	223 x 153 x 31 mm
Maximum data transfer rate	0.108 Gbit/s
Security algorithms	WPA-PSK
Networking standards	IEEE 802.11b, IEEE 802.11g
Supports ISDN connection	No
Ethernet LAN (RJ-45) ports	4

Weight and Dimensions

Weight	500 g