NETGEAR SXR80 User Manual

Orbi Pro WiFi 6 System LEDs
The following table describes the LED behavior for an Orbi Pro WiFi 6 router (model
SXR80) and Orbi Pro Wifi 6 satellite (model SXS80) that are purchased together and
come in the same package.
Table 1. Orbi Pro WiFi 6 System router and satellite LED descriptions
LED BehaviorLED
The Power LED is located adjacent to the power connector on the rear panel.
•
Solid green. Power is on.
•
Solid amber. The router or satellite is booting.
•
Blinking amber. The router or satellite is resetting to factory default settings.
•
Blinking red. The firmware is corrupted.
•
Off. Power is not supplied.
Power LED
The bar LED is located on the front.
•
Pulsing white. The router is booting or someone pressed the Sync button.
•
Off. The router finished booting and is working normally.
•
Solid white. The router is resetting to factory default settings.
•
Solid magenta. The router cannot connect to the Internet. See You cannot access the
Internet on page 162.
Router bar LED
This satellite is included when you buy an Orbi router. The bar LED is located on the front.
•
Pulsing white. The satellite is booting.
•
Blue for three minutes. The connection between the satellite and the router is good.
•
Amber for three minutes. The connection between the satellite and the router is fair.
•
Magenta. The satellite failed to sync to the router. See The router and satellite do not
sync on page 160.
•
Off. The satellite synced to the router and is working normally.
Satellite bar
LED
Add-on Orbi Pro WiFi 6 satellite LEDs
The following table describes the LED behavior for an add-on Orbi Pro WiFi 6 satellite
(model SXS80) that was purchased separately from the Orbi Pro WiFi 6 System kit.
User Manual11Overview
Orbi Pro WiFi 6 Router SXR80 and Orbi Pro WiFi 6 Satellite SXR80

NETGEAR SXR80 Specifications

General

Brand	NETGEAR
Model	SXR80
Category	Network Router
Language	English