Add satellites to your network using the router web interface
You can use the Orbi Pro WiFi 6 router web interface to add a satellite to your Orbi
network.
To add a satellite to your Orbi network using the router web interface:
1.
Launch a web browser from a computer or mobile device that is connected to your
Orbi network.
2. Enter orbilogin.com.
A login window opens.
3. Enter the router admin user name and password.
The user name is admin. The default password is password. The user name and
password are case-sensitive.
The BASIC Home page displays.
4. Select Add Orbi Satellite.
The Place Your Satellite page displays.
5. Follow the instructions about where to place your satellite in your house.
6. Connect the satellite to a power source.
7.
If the Power LED on the back of the satellite does not light, press the Power On/Off
button.
8. Click the NEXT button.
9.
Wait about two minutes for the satellite’s bar LED to light solid white.
10. Press the Sync button on the satellite.
The satellite’s bar LED pulses white.
11.
Click the SYNC button in the router web interface.
The router attempts to sync with the satellite.
The satellite’s bar LED lights one of the following colors for about three minutes and
then turns off:
•
Blue. The router and satellite successfully synced, and the connection between
the router and satellite is good.
•
Amber. The router and satellite successfully synced, and the connection between
the router and satellite is fair. Consider moving the satellite closer to the router.
•
Magenta. The router and satellite failed to sync. Move the satellite closer to the
router and try again.
User Manual19Overview
Orbi Pro WiFi 6 Router SXR80 and Orbi Pro WiFi 6 Satellite SXR80
To Next Page
Loading...
Need help?
General
