Wireless Configuration and Security
44
ProSAFE Dual-Band Wireless AC Access Point WAC720 WAC730
Restrict Wireless Access by MAC Address
For increased security, you can restrict access to an SSID by allowing access to only specific
computers or wireless stations based on their MAC addresses. You can restrict access to
only trusted computers so that unknown computers cannot connect wirelessly to the wireless
access point. MAC address filtering adds an obstacle against unwanted access to your
network, but the data broadcast over the wireless link is fully exposed.
Note: For wireless adapters, you can usually find the MAC address printed
on the wireless adapter.
To restrict access based on MAC addresses:
1. Select Configuration > Security >
Advanced > MAC Authentication.
2. Select the Turn Access Control On check box to enable the access control feature.
3. From the Select Access
Control Database menu, select a database option:
• Local MAC
Address Database. The wireless access point uses the local MAC
address database for access control. This is the default setting.
• Remote MAC
Address Database. The wireless access point uses the MAC address
database on an external RADIUS server on the LAN for access control. If you select
this database, you first must configure the RADIUS server settings (see Configure
RADIUS Server Settings on page 41).
4. Click the Refresh button to refresh the
Available Wireless Stations table.
To Next Page
Loading...
