Advanced Configuration
89
ProSAFE Dual-Band Wireless AC Access Point WAC720 WAC730
The captive portal is enabled on the selected SSID.
Configure Wireless Bridging
The wireless access point supports a wireless distributing system (WDS) that lets you build
large bridged wireless networks. You can select from the following wireless access point
modes:
• Wireless point-to-point bridge. In this mode, the wireless access point can
communicate with another bridge-mode wireless station and, as an option, also with
wireless clients. Use WPA-PSK,or WPA2-PSK to secure the communication. For
information about how to configure this mode, see
Configure a Point-to-Point Wireless
Network on page 89.
• Wireless point-to-multipoint bridge. In this mode, the wireless access point is the
master for a group of bridge-mode wireless stations. As an option, the wireless access
point can also communicate with wireless clients. You can configure up to four profiles.
The other bridge-mode wireless stations must be set to point-to-point bridge mode, using
the MAC address of the master wireless access point. Rather than communicating
directly with each other, all other bridge-mode wireless stations send their traffic to the
master wireless access point. Use WPA-PSK or WPA2-PSK to secure the
communication. For information about how to configure this mode, see
Configure a
Point-to-Multipoint Wireless Network on page 92.
• Repeating the wireless signal. In this mode, this wireless access point repeats the
wireless signal, does not support communication with wireless clients, and sends all
traffic to a remote access point. In this mode, wireless clients cannot associate with the
wireless access point. Use WPA-PSK or WPA2-PSK to secure the communication. For
information about how to configure this mode, see
Configure the Wireless Access Point to
Repeat the Wireless Signal Using Point-to-Multipoint Bridge Mode on page 94.
Note: You cannot configure wireless bridging when automatic channel
selection is enabled. On the basic Wireless Settings page, make sure
that Auto is not selected from the Channel / Frequency menu (see
Configure the Basic Wireless Settings on page 19).
Configure a Point-to-Point Wireless Network
In point-to-point bridge mode, the wireless access point communicates with another
bridge-mode wireless station. Use wireless security to protect this communication. The
following figure shows an example in which two wireless access points (APs) function in
point-to-point bridge mode:
To Next Page
Loading...
Need help?
General
