Supplemental Information
110
ProSAFE Dual-Band Wireless AC Access Point WAC720 WAC730
Factory Default Settings
You can use the Reset button located on the rear of the wireless access point to reset all
settings to their factory defaults. This is called a hard reset.
To perform a hard reset, use a sharp object to press and hold the Reset button for
approximately 5
seconds (until the Test LED blinks rapidly). This returns the wireless access
point to the factory configuration settings that are shown in the following table.
Note: Pressing the Reset button for a shorter period of time simply causes
the wireless access point to reboot.
Table 3. Default configuration settings
Feature Description
Login for management and configuration
LAN IPv4 management address 192.168.0.100
Subnet mask for IPv4 management address 255.255.255.0
LAN IPv6 management address 2001::21c:c0ff:fe69
User name (case-sensitive) for login admin
Login password (case-sensitive) for login password
LAN and management features
DHCPv4 client Enabled
DHCPv6 client Disabled
Untagged VLAN Enabled, VLAN ID 1
Management VLAN VLAN ID 1
SNMP Enabled
Syslog Disabled
Spanning Tree Protocol (STP) Disabled
Link Layer Discovery Protocol (LLDP) Enabled
Secure Shell (SSH) Enabled
Telnet Disabled
To Next Page
Loading...
