NETGEAR WAC730

Management and Monitoring
68
ProSAFE Dual-Band Wireless AC Access Point WAC720 WAC730
Configure Ensemble Mode
 To configure Ensemble mode on the access point:
1. Select Configuration > Ensemble.
2. T
o enable Ensemble mode, select the Start radio button.
3. In the Ensemble Name field, enter the ensemble name.
4. Set the access point’
s priority in the ensemble.
The lowest numbered AP becomes the dominant AP.
5. Click the Apply button to save your settings.
Manage an Ensemble
An ensemble can be managed through the dominant access point’s web management
interface, or through a configured IP address of the ensemble. You can manage an
ensemble’s channel assignment settings, upgrade settings, and security settings.
 To manage an Ensemble’s channel assignment settings:
1. Select Configuration > Ensemble >
Advanced > Channel Assignment Settings.
2. From the Channel Interference Limit menu, select an interference limit percentage.
3. Select an channel selection interval from the Channel Selection Interval menu.
4. Click Apply to save your settings.
You can monitor the channel’s used by the access points in the ensemble by selecting
Configuration > Ensemble >
Advanced > Channel Assignment.