NETGEAR WAC730

Advanced Configuration
86
ProSAFE Dual-Band Wireless AC Access Point WAC720 WAC730
Note: Rate limiting for the wireless interface is an optional setting that
applies to all traffic on the wireless interface. Unlike classification rate
limiting, which you can specify for each classification, rate limiting for
the wireless interface you only must specify once.
 To specify rate limiting for the wireless interface:
1. Specify rate limiting for the entire wireless interface as explained in the following table:
Setting Description
Bits Per Sec. Enter a value between 0 and 300,000,000 bps to specify the maximum
data rate up to which packets are queued for transmission and sent
immediately over the wireless interface.
This value applies to all traffic
on the wireless interface.
Note: When the maximum rate is exceeded, packets are retained in
the queue and sent when the transmission falls again below the
maximum rate.
Burst Rate
(Bytes)
Enter a value between 0 and 37,500,000 bytes to specify the maximum
amount of data that can be transmitted in a burst over the wireless
interface.
This value applies to all traffic on the wireless interface.
2. Click the Apply button to save your settings.
 To modify a QoS policy:
1. From the Create Policy menu, select the policy that you want to modify
.
2. T
o delete a classification, select it in the Classification field, and click Delete Classification.
3. T
o add a classification, see Step 4 through Step 6 in the procedure to configure a new QoS
policy. You can also change the name of the policy.
4. Click the Apply button to save your settings.
 To delete a QoS policy:
1. From the Create Policy menu, select the policy that you want to delete.
2. Click the Delete Policy button.
3. Click the Apply button to save your settings.
Interface
Rate Limiting