NETGEAR WAC730

Advanced Configuration
85
ProSAFE Dual-Band Wireless AC Access Point WAC720 WAC730
5. (Optional) Specify rate limiting for the classification as explained in the following table:
Setting Description
Bits Per Sec. Enter a value between 0 and 300,000,000 bps to specify the maximum
data rate up to which packets that match the classification are queued
for transmission and sent immediately over the wireless interface.
This
value applies only to traffic that matches the classification.
Note: When the maximum rate is exceeded, packets are retained in
the queue and sent when the transmission falls again below the
maximum rate.
Burst Rate
(Bytes)
Enter a value between 0 and 37,500,000 bytes to specify the maximum
amount of data that can be transmitted in a burst for packets that match
the classification.
This value applies only to traffic that matches the
classification.
6. Click the Add button to add the classification to the Classifications field.
7. T
o add another classification to the QoS policy, repeat Step 4, Step 5, and Step 6.
8. Click the Apply button to save your settings.
The QoS policy is saved.
Match Frame
Fields and Match
Classifications
(continued)
Source IP In the Match Classifications field, enter the source IP address against
which the information in the IP header needs to be matched.
Destination IP In the Match Classifications field, enter the destination IP address
against which the information in the IP header needs to be matched.
Source Port The Match Classifications field is separated into two sections. In the
left section, enter the source port number
, and optionally, in the right
section, enter the associated IP address against which the information
in the IP header needs to be matched.
Destination
Port
The Match Classifications field is separated into two sections. In the
left section, enter the destination port number
, and optionally, in the
right section, enter the associated IP address against which the
information in the IP header needs to be matched.
Apply
Classification
From the Apply Classification menu, select the traf
fic class that needs to be applied to
the packets that match the selection in the Match Classifications field:
• Best Effort(0)
• Background(1)
• Spare(2)
• Excellent(3)
• Control Load(4)
• V
ideo < 100 ms Latency(5)
• V
oice < 10 ms Latency(6)
• Network Control(7)
Classification
Rate Limiting
Setting Description