EasyManuals Logo

NETGEAR WG602 - 54 Mbps Wireless Access Point User Manual

NETGEAR WG602 - 54 Mbps Wireless Access Point
122 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #57 background imageLoading...
Page #57 background image
Troubleshooting 6-1
M-10181-03
Chapter 6
Troubleshooting
This chapter provides information about troubleshooting your 54 Mbps Wireless Access Point
WG602 v2. After each problem description, instructions are given to help you diagnose and solve
the problem. For the common problems listed, go to the section indicated.
Is the WG602 v2 on?
Have I connected the wireless access point correctly?
Go to “Installing the 54 Mbps Wireless Access Point WG602 v2” on page 3-4.
I cannot remember the wireless access point’s configuration password.
Go to “Changing the Administrator Password” on page 4-6.
Troubleshooting
If you have trouble setting up your WG602 v2, check the tips below.
No lights are lit on the access point.
The access point has no power.
Make sure the power cord is connected to the access point and plugged in to a working power
outlet or power strip.
Make sure you are using the correct NETGEAR power adapter supplied with your access
point.
The Ethernet LAN light is not lit.
There is a hardware connection problem.
Note: For up-to-date WG602 v2 installation details and troubleshooting guidance visit
www.netgear.com/support/main.asp.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR WG602 - 54 Mbps Wireless Access Point and is the answer not in the manual?

NETGEAR WG602 - 54 Mbps Wireless Access Point Specifications

General IconGeneral
Maximum Data Rate54 Mbps
Frequency Band2.4 GHz
SecurityWEP, WPA, WPA2
Wireless StandardIEEE 802.11g
Ports1 x 10/100 Mbps Ethernet
Power Supply12V DC
Compliant StandardsIEEE 802.11g, IEEE 802.11b

Related product manuals