NB3700 User Manual 3.8
5.7.4. NTP Server
This section can be used to individually configure the Network Time Protocol (NTP)
server function.
Figure 5.41.: NTP Server
The following settings for each interface can be applied then:
Parameter NTP Server Settings
Administrative status Specifies whether the NTP server is enabled or not
Poll interval Defines the polling interval (64..2048 seconds) for synchro-
nizing the time with the master clock servers
Allowed hosts Defines the IP address range which is allowed to poll the
NTP server
For setting the system time of the device see 5.8.1.
112
To Next Page
Loading...
