NB3700 User Manual 3.8
5.6.5. Dial-In
On this page you can configure the Dial-In server in order to establish a data connection
over GSM calls. Thus, one would generally apply a required service type of 2G-only, so
that the modem registers to GSM only. Naturally, a concurrent use of outgoing WWAN
interfaces and Dial-In connection is not possible.
Figure 5.36.: Dial-in Server Settings
The following settings can be set:
Parameter Dial-in Server Configuration
Administrative status Specifies whether incoming calls shall be answered or not
Modem Specifies the modem on which calls can come in
Address range start Start of the IP address range assigned to incoming clients
Address range size Number of addresses for client IP address range
Besides the admin account you can configure further users in the user accounts section
95
To Next Page
Loading...
