NB3700 User Manual 3.8
WLAN IP Settings
This section lets you configure the TCP/IP settings of your WLAN network. A client
interface can be run over DHCP or with a statically configured address and default
gateway.
Figure 5.14.: WLAN IP Configuration
The access point networks can be bridged to any LAN interface for letting WLAN clients
and Ethernet hosts operate in the same subnet. However, for multiple SSIDs we strongly
recommend to set up separated interfaces in routing-mode in order to avoid unwanted
access and traffic between the interfaces. The corresponding DHCP server for each
network can be configured in afterwards as described in chapter 5.7.2.
Parameter WLAN IP Settings
Network mode Choose whether the interface shall be operated bridged or
in routing-mode
Bridge interface If bridged, the LAN interface to which the WLAN network
should be bridged
50
To Next Page
Loading...
