NB3700 User Manual 3.8
Automatic File Configuration
This menu can be used to run an automatic configuration update of the system. It is
configured as follows:
Parameter Automatic File Configuration
Status Enable/disable an automatic configuration update
Time of day Time of day when the system should check for updates
URL The URL where the configuration file should be retrieved
from (supported protocols are HTTP, HTTPS, TFTP, FTP)
Factory Configuration
Figure 5.58.: Factory Configuration
This menu can be used to reset the device to factory defaults. Your current configuration
will be lost. This procedure can also be initiated by pressing and holding the Reset
button for at least five seconds. A successfully initiated factory reset can be noticed by
all LEDs having been turned on. The factory reset will set the IP address of the first
148
To Next Page
Loading...
