NetModule NB3700 - Page 125

NB3700 User Manual 3.8
Typical SNMP Commands
Setting MIB values and triggering extensions is generally limited to the SNMPv3 admin
user. It is possible to specify an administrative host for SNMP v1/2c.
The SNMP extensions can be read and triggered as follows:
Getting the software version of the system:
snmpget -v 3 -u admin -n "" -l authNoPriv -a MD5 -x DES -A admin01admin01
192.168.1.1 1.3.6.1.4.1.31496.10.40.1.0
Getting the kernel version:
snmpget -v 3 -u admin -n "" -l authNoPriv -a MD5 -x DES -A admin01admin01
192.168.1.1 1.3.6.1.4.1.31496.10.40.2.0
Getting the serial number:
snmpget -v 3 -u admin -n "" -l authNoPriv -a MD5 -x DES -A admin01admin01
192.168.1.1 1.3.6.1.4.1.31496.10.40.3.0
Restarting the device:
snmpset -v 3 -u admin -n "" -l authNoPriv -a MD5 -x DES -A admin01admin01
192.168.1.1 1.3.6.1.4.1.31496.10.40.10.0 i 1
Running a configuration update:
snmpset -v 3 -u admin -n "" -l authNoPriv -a MD5 -x DES -A admin01admin01
192.168.1.1 1.3.6.1.4.1.31496.10.40.11.0 s "http://server/directory"
You can use TFTP, HTTP, HTTPS and FTP URLs (specifying a username/password
or a port is not yet supported). Please note that config updates expect a zip-file named
<serial-number>.zip in the specified directory.
Getting the configuration update status:
snmpget -v 3 -u admin -n "" -l authNoPriv -a MD5 -x DES -A admin01admin01
192.168.1.1 1.3.6.1.4.1.31496.10.40.12.0
The return value can be one of: succeeded (1), failed (2), inprogress (3), notstarted
(4).
Running a software update:
snmpset -v 3 -u admin -n "" -l authNoPriv -a MD5 -x DES -A admin01admin01
192.168.1.1 1.3.6.1.4.1.31496.10.40.13.0 s "http://server/directory"
Getting the software update status:
snmpget -v 3 -u admin -n "" -l authNoPriv -a MD5 -x DES -A admin01admin01
192.168.1.1 1.3.6.1.4.1.31496.10.40.14.0
125