NB3700 User Manual 3.8
Parameter System Settings
Syslog redirect address Specifies an IP address to which system log messages should
be redirected to. A tiny system log server for Windows is
included in TFTP32 which can be downloaded from our
website.
Syslog max. file size The maximum size of message log files in kilobytes until
they will be rotated
Reboot delay The number of seconds which will be waited before regu-
lar system reboots (might be needed for system-rebooting
events)
Enable discovery Enables host discovery over LLDP (Link Layer Discovery
Protocol), CDP (Cisco Discovery Protocol), FDP (Foundry
Discovery Protocol), SONMP (Nortel Discovery Protocol)
and EDP (Extreme Discovery Protocol). IRDP implements
RFC1256 and can also inform locally connected hosts about
the nexthop gateway. Any discovered hosts will be ex-
posed to the LLDP-MIB and can be queried over SNMP
or CLI/GUI.
Banks to be displayed You can configure the behavior of the status LEDs on the
front panel of your device. They are usually divided into two
banks (top/bottom) and are either indicating the connec-
tion status or the digital IO port status. You may configure
toggle mode, so that the LEDs periodically cycle between
the two states.
Time & Region
This page can be used for setting the system time and configuring the time zone. You
may further enable daylight saving changes (e.g. automatically switching from summer
to winter time) for your specific time zone.
NetModule routers can synchronize their system time by using one or more servers
by the help of the Network Time Protocol (NTP) or via GPS. If enabled, the time
synchronization is usually triggered after a WAN link has come up but before starting
any VPN connections. Further time synchronization cycles are scheduled in background.
Parameter Time & Region
Time Synchronisation Enable/disable time synchronization
NTP server Address of the primary NTP server
138
To Next Page
Loading...
